Hypertherm THC2 Torch Height Control Manuel d'utilisateur télécharger pdf (Page 11)

THC-2 Torch Height Control

Page 1-3

INSTALLATION - To Cutting Machine & Torch Lifter

2. To ensure proper grounding at the THC-2, run a #10 gauge copper cable from the ground

stud on the rear of the THC-2 (Fig. 1-2) to a common earth ground. To correctly operate

the THC-2 system, it must be grounded properly.

Connect the THC-2 Control Module to the Cutting Machine Computer Interface

and Torch Lifter Motor

A cable running from the THC-2 control module to the cutting machine interface and torch

lifter must be fabricated. Hypertherm recommends a 7-conductor 24-gauge shielded cable.

3. Remove the eight screws on the THC-2 Control Module and take off the top

panel - Fig. 1-2.

Figure 1-2 THC-2 Control Module Front and Rear Views

Remove Screws

Strain

Reliefs

Ground

Stud

RECP2

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 40 41

Pas de commentaire

Hypertherm THC2 Torch Height Control Manuel d'utilisateur Page 11