Hypertherm THC2 Torch Height Control Manuel d'utilisateur télécharger pdf (Page 24)

THC-2 Torch Height Control

INSTALLATION - PAC-500

Page 1c-3

INSTALL THE INTERCONNECT CABLE TO PAC-500

1. The cable from the THC-2 to the PAC-500 console must be fabricated. Hypertherm

recommends using 3-pair 22-gauge shielded cable. The cable will run between the

plasma control console and the THC-2 module. Be certain to supply a cable that will

reach between these two components.

2. Strip the outer shielding away on both ends of the cable and tag individual wire ends 1

through 6. Tag both ends so that wire "1" on one end is the same wire that is marked "1"

on the other end, etc.

3. Crimp #6 terminals on all wires on one end of the cable. On the other end of the cable,

crimp #6 terminals on wires 4 and 6 and strip and tin the remaining wires.

4. Feed the cable end with all terminals attached through one of the strain reliefs of the

plasma control console - Fig. 1c-2.

Figure 1c-2 PAC-500/500L Plasma Control Consoles

Strain Reliefs

GAS OUT

WATER OUT

Strain Reliefs

PAC-500

PAC-500L

Strain Reliefs

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 40 41

Pas de commentaire

Hypertherm THC2 Torch Height Control Manuel d'utilisateur Page 24